推薦施工方式：刷涂或噴涂。面漆建議用噴涂施工，漆膜效果更佳。
施工工藝：涂裝工藝（以水曲柳板為例）
耗漆量（理論值）：面漆：8-10平方米/公斤(混合液，刷涂一遍的耗量)
底漆：5-7平方米/公斤(混合液，噴涂一遍的耗量)
(因基材、涂料顏色和效果不同，耗漆量會有所不同)
干燥時間(溫度25℃、相對濕度75%)：表干時間小于60分鐘 實干時間12小時
可使用時間(溫度25℃、相對溫度75%)：油漆混合后應在4小時以內用完。
重涂時間(溫度25℃、相對濕度75%)：
如果采用濕噴濕涂飾方法，在漆膜表干以后馬上重涂，中間無需打磨。但底
漆施工4小時，面漆施工8小時后如果還要進行下步涂裝，則必須對涂層進行
打磨，以增加漆膜間的附著力。
施工注意事項：
①配漆時，將罐內油漆充分攪拌均勻，按規定比例調配，再次攪拌均勻，靜
置10分鐘后過濾使用。
②請將被涂物表面的灰塵、顆粒清理干凈，再涂飾下一道漆。
③開罐后若油漆不能一次用完則必須即時密封。
④請配套使用本公司產品，以免引起不良反應。
⑤請根據溫度的變化選擇配套的稀釋劑。
⑥基材的含水率應與當地的平衡含水率相當，表面要求干燥清潔。
⑦施工時應配戴防護用具，并保持良好通風。
⑧請根據施工難度和漆膜效果及時改變稀釋的加入量。
儲存方式：密閉存于陰涼干燥處，遠離明火及熱源。
符合國家標準：GB18581-2001

Recommended construction method: Brush or spray. Spray paint is recommended, the film better.
Construction Technology: coating process (as Ash board as an example)
Consumption of paint (theoretical): finish 8-10 square meters / kg (the mixture, brush over the consumption)
Primer :5-7 sq m / kg (the mixture, spraying over the consumption)
(Due to the substrate, coating with different colors and effects, the consumption of paint will vary)
Drying time (temperature 25 ℃, relative humidity 75%): dry time of less than 12 hours, 60 minutes drying time
Can use the time (temperature 25 ℃, relative humidity 75%): paint mixture should be used within 4 hours.
Recoat time (temperature 25 ℃, relative humidity 75%):
If the wet-jet wet coating method, immediately after the film is dry coating weight, in the middle without polishing. But at the end
Construction paint 4 hours, 8 hours after the finish the construction but also the next step if the coating, the coating must be
Polished, in order to increase the adhesion between the film.
Construction Notes:
① with paint, paint the tank, stir, according to the provisions of the proportion of allocation, stir again, the static
10 minutes after the filter is set to use.
② Please be coated surface of the dust particles to clean up, and then finishing the next coat of paint.
③ If the paint can that can not run out of time must be immediately sealed.
④ Please supporting the use of our products, so as to avoid adverse reactions.
⑤ Please select the package according to the temperature change of the diluent.
⑥ the moisture content of the substrate should be fairly local equilibrium moisture content, surface requires dry and clean.
⑦ construction should wear protective equipment, and maintain good ventilation.
⑧ film according to difficulty of construction and the addition of dilution effect of changes in the amount of time.
Storage: kept in a cool dry place sealed, away from open flame and heat.
Meet the national standard: GB18581-2001